HS 22 Series Gear Type Hydraulic Starter
 Gear Motor Hydraulic Starters
- Friction Clutch Inertia Drives
These starters are adapted from PRQ’s 23/24 and 60/61 series air starters.
- They can be purchased with or without motors.
- Both use friciton clutch starter drives.
Highlights:
- Continuous duty motors
- S.A.E. mounting pads
- Heavy-duty starter drives
- Models to fit both sides of multi-pad engines
- Can be purchased less motor
- Side and rear ports
HS-222 1 cu. in. (16.4 cc)
HS-223 2 cu. in. (32.8 cc)
HS-224 3 cu. in. (49.2 cc)
HS-360 5.15 cu. in (84.3 cc)
HS starters are now available with a Smart-R-Valve™ i nstalled and tested at the factory. How easy is that?
The
HS 22 Series of hydraulic starters are based on
the LS 23/24 air/gas starters. The drive housing
has been adapted to a Permco hydraulic gear motor
to create the starter. The heavy duty friction
clutch is used as the drive for the HS 22 series.
Different gear widths are used in the series 31
Permco motor to give the correct torque and speed
to match different engine requirements. The starters
come in both left and right hand rotations. The
motors have case drains to relieve excessive back
pressure that can cause seal failure. The HS series
will take up to 3,000 psi and the oil flow varies
with different gear width that are used for different
models and applications. The motors have rear ports
that have SAE “O” ring boss fittings.
The HS 22 series will start engines from 500 CID
to 3,000 CID. These starters may be used with closed
loop systems used on many “frac” truck
applications as well as accumulator based systems.
These starters are modular and the front end can
be changed without disconnecting the hydraulic
motor from the system. Weep holes are placed in
the adaptor spool as tell tales if any leaks would
occur that could damage the engines clutch or transmission.
|
